Site Map |   

Home > News > Automatic wire stripping machine for common faults and solutions

Automatic wire stripping machine for common faults and solutions

Automatic  wire stripping machine head and peeled open
1, check the cutting depth of the line, adjust the diameter value is smaller.
2, input line transmission wheel clearance is too large, adjust the line transmission wheel clearance.
3, stripping the head set is greater than 2mm.
4, into line with possession of stolen goods.
5, retracts the setting is too large, required is reduced.


 

Wire stripper wire stripping won't open
1, check the cutting depth of the line, adjust the diameter value is smaller.
2, the gap is too large transmission wheel outlet, smaller round transport wheel clearance.
3, stripping the head set is greater than 2mm.
4, retract the setting is too large, you want smaller.


 

Line Peel crushed
1, adjust the gap between line and wire transfer rounds.
2, to contact the factory and replace the transport wheels.


 

Core cut
1, larger diameter value, until the appropriate degree (blade cut the thread but hurt core for the best position).
2, if the line is very thin, find it impossible to peel after transfer to the wire diameter, it may be appropriate to reduce the exit value.


 

Varies, an actual length is greater than or equal to the setting and yarn length
1, input line transmission wheel clearance is too large, and sometimes Peel up lint, thread stripping not open line is greater than the set length, adjust the "into the gap adjustment wheel", increasing the pressure.
2, into the duct for booty, check and properly cleaned.
3, adjust the line transmission wheel pressure.


 

Varies, an actual length is less than or equal to the setting and yarn length
1, wire itself vary in thickness.
2, scroll Round booty, needs cleanup. Wire coated with wax, lead in-and-out transmission wheel skidding.
3, take out, the program is set to "00", run, stop, check the "inlet and outlet wheel" rotating flexible or jammed.
4, frame lock phenomenon, an input line appears slipping.


 

Some wire is too long
1, wire diameter too small, punch and cut to the core, while stripping out, increase line width value you want 1-2.
Retract set 2, is too young to suitably increase the retract parameter.


 

Sometimes wires together without cutting
1, parts of the knife-edge activities plus motor oil, try again (generally per running 8-hour refueling).
2, slow speed, then try again.
3 in this models, check the wire specifications models permit limits.
4, the blade is blunt.


 

Tangential incision when tilted
1, the wire itself is too bent, straight you want.
2, wire has come to Center blade.